ArcWear performs vertical flame testing for textiles in accordance with ASTM D which is used in ASTM F, ASTM F, and NFPA We will report. 23 Jul Some updates have been made to ASTM D Standard Test Method for Flame Resistance of Textiles (Vertical Test) commonly used in flame. ASTM D Test Method for Flame Resistance of Textiles. (Vertical Test). • Pass criteria: max char length of 10 cm. • After-flame of not more than 2 seconds.
|Published (Last):||17 January 2015|
|PDF File Size:||7.20 Mb|
|ePub File Size:||1.6 Mb|
|Price:||Free* [*Free Regsitration Required]|
The values stated in each system may not d64413 exact equivalents; therefore, each system shall be used independently of the other. Afterglow is the number of seconds during which there is a astm d6413 glow remaining on the fabric.
ASTM D – 99 Standard Test Method for Flame Resistance of Textiles (Vertical Test)
ASTM D is used to determine flame resistance of fabrics used to protect against both astm d6413 arc and flash fire hazards. The ASTM D test method is utilized to evaluate the flame resistance of every production lot astm d6413 fabric used in Tyndale-branded clothing.
The test results from the two laboratories should be astm d6413 using a statistical test for unpaired data, at a probability level chosen prior to the testing series. Link to Active This link will always route astm d6413 the current Active version of the standard.
As a minimum, the test samples used should be as homogeneous as possible, that are drawn from the astm d6413 from which the disparate test f6413 are obtained, and that are assigned randomly in equal numbers to each laboratory for testing. Notify me of follow-up comments by email. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Adopted from Federal Test Standard No. After exposure to the flame, afterflame, afterglow and char length are measured: July 10, at 9: The occurrence of melting or dripping, ast any, is also recorded. Five tests are performed and the results are averaged and reported as the final test result. Garments that meet these standards are used to comply with: Char Length is the length in inches of astm d6413 destroyed astk the flame. Afterflame is the number of seconds during which there astm d6413 a visible flame remaining on the fabric.
If a bias is found, either its cause must be found and corrected, or future test results must be adjusted in consideration on the known bias. Work Item s – proposed astm d6413 of this standard. Save my name, email, and astm d6413 in this browser for the next time I comment. Notify me of new posts by astm d6413. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Other materials with established test values may be used for this purpose. Leave a Reply Cancel reply Your email address will not be published.
Astm d6413 between-laboratory precision of this test method has not been established.
Your email address will not be published. Historical Version s – view previous versions of standard. Astm d6413 values from the two systems may result in non-conformance with the standard. ICS Number Code The cut edge of the fabric on the bottom is astm d6413 to a controlled methane flame for 12 seconds as seen in the image above, left.
The purpose of this test is to determine whether a fabric will continue to v6413 after the source of ignition is removed. Astm d6413 performs voluntary asgm auditing on Tyndale garment fabrics. Refer to Section 14 for single-laboratory precision.
We are Proud to Protect workers, and understand that our dedication to testing is the only way to ensure that our garments perform as expected — every time! This is astm d6413 defining dd6413 method for compliance with OSHA